Recoil spring replacement - Kimber Forum

Kimber


Go Back   Kimber Forum > Kimber Forum Discussions > Gunsmith

Reply
 
LinkBack Thread Tools Display Modes
Old 11-05-2018, 02:20 PM   #1
Junior Member
 
Einstein's Avatar
 
Join Date: Dec 2016
Posts: 18
Recoil spring replacement

Have this Ultra Carry II in .45. it's an older model seen about 2500 rnds. I've been working on it lil by little. Should recoil assembly be replaced or do I just grab outer spring from Kimber? Everything else is good. It functions fine. Did notice my shells were flying further than my buddies? I appreciate the input.
Einstein is offline   Reply With Quote
Remove Ads
Old 11-05-2018, 02:56 PM   #2
Senior Member
 
Shootinit's Avatar
 
Join Date: Jan 2017
Posts: 3,903
just spring if nothing is damaged...
Shootinit is offline   Reply With Quote
Old 11-06-2018, 07:49 AM   #3
Senior Member
 
Chickadee's Avatar
 
Join Date: May 2014
Location: Colorado
Posts: 2,323
I second that. No need to replace the rod if it's not damaged. I usually also replace my firing pin spring at the same time as the recoil spring.
__________________
If everything seems under control, you're just not going fast enough.

Mario Andretti
Chickadee is offline   Reply With Quote
 
Old 11-07-2018, 10:13 AM   #4
Junior Member
 
Einstein's Avatar
 
Join Date: Dec 2016
Posts: 18
Ya... thanks. Talked to Kimber service. They sent me out a outer recoil spring. $7.50. not bad. Assembly $42.00. According to them the other guide rod spring needs no replacing...just the #18 outer.
Einstein is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Is it worth it? BlondeBear63 Kimber Micro 9 Forum 84 07-04-2017 12:23 AM
Recoil spring orientation BWozn14k Kimber Micro 9 Forum 4 02-25-2017 09:45 PM
Micro 9 replacement recoil spring micway71 Kimber Micro 9 Forum 37 02-07-2017 04:29 PM
Stainless Target II recoil spring 10mm sigman45acp Kimber 1911 Forum 2 10-05-2016 11:25 PM
SIS Ultra saved from a trade in Mike240 Gunsmith 24 08-30-2016 09:41 PM