Kimber slide milling for vortex venom. - Kimber Forum


Go Back   Kimber Forum > Kimber Forum Discussions > Gunsmith

LinkBack Thread Tools Display Modes
Old 07-08-2020, 04:12 PM   #1
Senior Member
bimmerland's Avatar
Join Date: Nov 2013
Posts: 143
Kimber slide milling for vortex venom.

I have an old kimber aegis custom II series 80 with swartz block. Can this slide be milled for a vortex venom. I plan to remove the block and rear sight. Do you of a company that can do this. Any suggestions greatly appreciated. Thanks
bimmerland is offline   Reply With Quote
Remove Ads
Old 07-08-2020, 06:21 PM   #2
Senior Member
Mike240's Avatar
Join Date: Aug 2013
Posts: 1,793
Yes it can be done and the safety can stay intact and functional as long as the slide is not cut deeper than existing dovetail at the location of the safety block.

Potentially could go deeper and remove material from the block but I would have take measurements.
Yea. Keep telling yourself that split times donít matter.
Mike240 is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On