[Hendog]

After a little snafu, I needed a new grip screw bushing for my Master Carry Pro. I ordered a set from Wilson Combat and they are too small. I didn't see any other sizes on any site I searched. Can someone tell me if these are proprietary to Kimber and/or where I can find the correct size screw bushing???

 

[Mike240]

I use EGW without issue on Kimbers in the past. They are standard.

 

[Chuck43]

There are two size bushings, standard .236 x 60 and oversize .255 x 60, is it possible the standard bushings were previously stripped out on you frame and replaced with oversize bushings?

 

[Hendog]

I'm the original owner and I've never even had one of the bushings out before. I did send the gun to Kimber after I bought it to have some warranty work done on it. Perhaps they did it and didn't mention it to me?

 

[Hendog]

Got through to Kimber CS. They say mine SHOULD still be normal size. They're going to send me all new bushings and screws at no charge. Sometimes I think I'm just too impatient with being on hold...