Kimber Talk Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 · (Edited)
What is minimum you have to do to be able to remove and then be able to reinstall the sear spring on a micro 9. For example can I just remove main spring housing or will I need to break it down further. I am familiar with 1911’s and I know the Micro 9 is similar but yet a little different. I own 1911’s and have worked on them before but I haven’t took the Micro 9 apart yet. I was hoping someone could give me some insight. Thanks
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #2 ·
I went ahead and dug into it and I’m not saying you couldn’t do it without removing anything but the main spring housing; but it’s a whole lot easier to remove the safety, the hammer, and one of the grips along with the main spring housing.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top